Longshine LCS-C842MT Bedienungsanleitung Seite 1

User’s Manual 10/100Base to 100Base-FX Switching Converter

10/100Base-TX to 100Base-FX Converter- 8 -Loopback TestThis converter features dip switches to activate local and remoteloopback test functions. Use l

10/100Base-TX to 100Base-FX Converter- 9 -Network Setup With Converter• Two LAN Switch workgroupsExample:switchßàCONVERTERßàCONVERTERßàswitch• A 10/10

10/100Base-TX to 100Base-FX Converter- 10 -• A 10/100 Switch and workstation (WS)Example: switchßàCONVERTERßàCONVERTERßàWS

10/100Base-TX to 100Base-FX Converter- 11 -3 LED IndicatorsThis converter has LED indicators located at the front of the device.

10/100Base-TX to 100Base-FX Converter- 12 -Rear View of Converter with AC Power SupplyPower: 90 - 240V AC (Optional 12V Adapter)Dimensions: 109 x 17

10/100Base-TX to 100Base-FX Converter- 13 -Appendix BConverter MountingThis converter can be placed in any location that will make itsinstallation con

10/100Base-TX to 100Base-FX Converter- 14 -Appendix CCablesThe following are some recommendations as to what you shouldand should not do when installi

10/100Base-TX to 100Base-FX Converter- 1 -1IntroductionProduct OverviewThe Enhanced 10/100 to 100Base-FX Switching Converter isdesigned for large work

10/100Base-TX to 100Base-FX Converter- 15 -Pin 1 TD+ Pair 2 White/Orange Pin 2 TD- Pair 2 Orange/White Pin 3 RX+ Pair 3 White/Green Pin 4

10/100Base-TX to 100Base-FX ConverterCOPYRIGHTAll rights reserved. No part of this publication may be reproduced,stored in a retrieval system, or tran

Table of Contents1. IntroductionProduct Overview ... 1Features ... 2Specifications ...

10/100Base-TX to 100Base-FX Converter- 2 -Features• Automatic MDI/MDI-X selection on RJ-45 port• Link Fault Signaling (LFS)• Store-and -forward at ful

10/100Base-TX to 100Base-FX Converter- 3 -SpecificationsStandard: IEEE 802.3 (10BASE-T Ethernet);IEEE 802.3u (100BASE-TX/FX Fast Ethernet)Connector: 1

10/100Base-TX to 100Base-FX Converter- 4 -Dimensions: 135.5x 86x 29 mm (LxWxH)Switches for: DIP 1 - Auto-negotiationDIP 2 - Copper port duplex modeDIP

10/100Base-TX to 100Base-FX Converter- 5 - 2InstallationTo install your converter, please see the following procedures:• MDI / MDI-

10/100Base-TX to 100Base-FX Converter- 6 -Switch SettingDIP 1 – Enables / disables auto-negotiationDIP 2 – Copper port (RJ45) duplex mode: full or hal

10/100Base-TX to 100Base-FX Converter- 7 -Link Fault Signaling (LFS)The LFS LED will immediately light to indicate when a cable hasbeen severed or whe