Longshine LCS-8038TXR7 Bedienungsanleitung PDF herunterladen (Seite 3)

1. Introduction

Congratulations on the purchasing of your new 10/100

NWay Fast Ethernet PCI adapter. This document describes

the Installation of network adapter. This adapter supports

10BASE-T/100BASE-TX Fast Ethernet and complies with

the electrical and protocol requirements of the PCI Local

Bus Specification, revision 2.2. The Wake-On-LAN feature

is optional for the adapter.

1.1 Features

The 10/100 Fast Ethernet PCI adapter is a cost effective,

high-performance network interface card. It operates in

10BASE-T and 100BASE-TX modes and integrates easily

with Fast Ethernet hub and switch.

y IEEE 802.3 10BASE-T and 100BASE-TX standards

y 32-bit bus master for high throughput and low CPU

utilization

y Wake-On-LAN feature is optional for different

hardware version

y Full-duplex operation at both 10Mbps and 100Mbps

y Supports 10/100Mbps auto-sensing capability

y Rich diagnostic LED mounted on bracket for easily

viewing and troubleshooting

y Single shield RJ-45 connector for using at either

Speed (Category 3, 4 or 5 UTP cable for 10Mbps

Operation, and Category 5 UTP cable for 100Mbps

Operation)

y Plug and Play Installation.

y Test program (include Wake-On-LAN events)

y Network drivers on the diskette for Windows 95, 98,

ME, NT, 2000, XP, NetWare, SCO Unix and Packet

driver.

y FCC, CE certification

1.2 System Requirements

To use the adapter, you need the following components:

y One PCI master mode expansion slot that is

compliant with PCI bus specifications, revisions 2.2

y A 3.5-inch,1.44MB diskette drive

y The following cables:

To operate at 10Mb/s, a Category 3, 4, 5 UTP Cable

E-3

To operate at 100Mb/s, a Category 5 UTP cable

1 2 3 4 5 6 7 8 ... 60 61

Keine Kommentare

Longshine LCS-8038TXR7 Bedienungsanleitung Seite 3