Longshine LCS-8038TXR7 Bedienungsanleitung PDF herunterladen (Seite 5)

2.2 Install the Adapter

1. Turn off the computer.

2. Remove the computer’s cover, in accordance to its

manual.

3. Insert the contact edge of the adapter card into the

connector of any available PCI Bus master expansion

slot. Press the card firmly into the connector to PCI slot.

Please make sure that the card’s contacts are fully

seated in the PCI slot.

4. Install the bracket screw that secures the card to the

Computer chassis.

5. Connect the WOL cable to the motherboard. (If adapter

supports WOL function)

6. Replace the computer’s cover.

7. Connect the CAT3 or CAT5 UTP cable to the RJ-45

network connector.

8. Remove [Drivers and Utilities] diskette from the PC

diskette drive.

9. Turn on the computer.

10. If the BIOS section of your computer’s boot program is

Plug and Play compliant, then at power up the BIOS will

configure any newly installed adapter automatically.

Note:

Due to some Plug-n-Play BIOS programs' problem, it

happens occasionally that a newly installed adapter is

assigned an Interrupt Number which is already used

by another device adapter. In such a case, the conflict

of Interrupt Number will cause faults in the behavior of

both devices. Then it is necessary to run the CMOS

Setup utility, and manually assign a non-conflict

Interrupt Number.

E-5

1 2 3 4 5 6 7 8 9 10 ... 60 61

Keine Kommentare

Longshine LCS-8038TXR7 Bedienungsanleitung Seite 5